Skip to content

Implements Direct Australia Implements Direct

PTO Shaft Sizes, Fitment and Shortening: What to Check

A PTO shaft must match the tractor and implement in connection type, speed, power rating and length. A shaft that bottoms out can damage the tractor or implement; one that extends too far can separate. Check every tractor-and-implement combination before use.

This is a fitment overview, not a universal cutting instruction. Obtain the manuals for your tractor, implement and exact PTO shaft. Have shortening carried out by a suitably qualified agricultural machinery technician, following those instructions.

Check spline count and PTO speed

Common PTO connection Splines Typical rated speed
1-3/8 in (about 35mm) 6 540rpm
1-3/8 in (about 35mm) 21 1000rpm
1-3/4 in (about 44.5mm) 20 1000rpm

These are common arrangements, not a guarantee for every tractor. Count the splines and check both equipment manuals. A spline adaptor changes the connection, not the PTO speed. Never run a 540rpm implement at 1000rpm unless its manufacturer expressly permits that setting.

1. Make the equipment safe

Disengage the PTO, park securely, stop the engine, remove the key and wait for all movement to stop before approaching the shaft. Safely support the implement. Keep people clear whenever the tractor or linkage must be moved to establish a measurement position, then shut down and secure it again before taking measurements.

2. Check the shortest and longest working positions

Do not judge shaft length only with the implement resting on the ground. Determine the minimum and maximum separation of the connections through the permitted operating and transport positions, using the measuring points specified by the manufacturer. Include relevant turning movement for a trailed implement. Changing the top link or adding a quick hitch can alter the required length.

The shaft must retain the specified compression clearance at its shortest position and the specified tube overlap at its longest. Also check permitted joint angles and clearance from the linkage and guards. Do not force the linkage against a shaft that is bottoming out.

3. Confirm whether shortening is permitted

There is no single clearance or overlap figure suitable for every shaft. Do not apply a blanket “subtract 75mm” calculation. Guard systems and internal lubrication arrangements may limit the amount that can be removed. If the required length cannot meet the manufacturer's limits, obtain the correct shaft rather than cutting further.

4. Shortening and reassembly

Where the manufacturer permits shortening, the technician must follow its method for marking and cutting the drive tubes and guard tubes. The work includes removing burrs and swarf, lubricating as specified, restoring the correct alignment of the shaft halves and refitting every guard component. Cutting only the plastic cover does not shorten the driveline.

5. Verify before engaging the PTO

Recheck minimum and maximum length after reassembly, with the PTO disengaged. Both end connections must lock securely. The tractor shield, driveline guards and implement shield must all be fitted and functional. Fit guard restraints as specified for that shaft, without restricting its movement. Never operate with missing or damaged guarding.

Only carry out the manufacturer's startup check after fitment is verified and everyone is clear. Stop immediately for unusual noise, vibration or interference. Never approach, step over or attempt to adjust a rotating shaft.

Illustrated manufacturer instructions

These illustrate why shaft-specific instructions matter; use the manual for your own equipment. Also see our three-point linkage pin-size guide.

If you cannot identify the shaft or find its instructions, contact Implements Direct Australia with photos, model numbers and the tractor/implement combination before making any cuts.

Search